User Manual For CYCLONE
FX
Programmers
32
that may be assigned to the AUX button are:
1. No Operation - No operation is assigned to the AUX button and it will not be displayed on
the LCD screen.
2. Perform Verify Only - Verifies the data on the target device against the data in the pro-
gramming image.
3. Toggle Power - Toggles the Cyclones power relays off/on.
4. Validate Image CRC32 - Validates the CRC32 of the data on the target device against that
of the data in the programming image.
5. Power Cycle Device To Run User Code - Toggles the target power and maintains tri-state
mode for all signals.
6. Launch Image Programming - Launches the selected programming image. Replaces the
hardware Start Button.
5.2.3.5
Configure Screen
This menu presents options that allow the user to adjust or customize the Cyclone’s LCD
touchscreen display in various ways.
5.2.3.5.1 Change Screen Brightness
Allows the user to adjust the brightness of the LCD touchscreen. The “Increase” and “Decrease”
buttons will raise or lower the brightness level, respectively, in increments of 10%. Brightness can
be adjusted from between 100% - 10%. Press “Done” to exit.
5.2.3.5.2 Calibrate Screen
Allows the user to click on specified points on the LCD touchscreen in order to calibrate the
accuracy of the touch function. Follow the on-screen instructions.
5.2.3.5.3 Set Progress Details
This configures the display to present more detailed information during the progress of
programming, including the specific programming steps that are performed and specific
information about the programming and verifying procedure. The user may select “Show Details,
Keep Last Progress On,” “Show Progress Details,” or “Hide Progress Details.”
5.2.3.5.4 Configure Home Screen
This menu allows you to choose what information to display on Lines 2-8 of the home screen.
Available elements to display consist if information such as: the current IP address, the Cyclone
name, the number of images, etc. In this way the user can customize the display to provide the
information that they find most useful. There is a separate button for each of Lines 2-8. Tapping on
the button for a specific Line brings up a list of elements that you can choose to display on that
Line of the home screen. If the list of elements is greater than one page, tap the More button to
view the rest of the available elements. Tap the element that you want to display on that line and
then tap Done to save your selection.
Note:
The
CYCLONE
FX
allows one additional option for display: the target device’s voltage and/
or current.
5.2.3.6
Configure Storage
This menu selection allows the user to format the Cyclone’s internal memory. This menu will also
allow the user to format an SD card located in the Cyclone’s memory expansion slot. Select
“Format Internal Storage” or “Format External SD Card”. The user will be prompted to ensure that
they wish to format the corresponding memory. Tap “Yes” to format, or “Cancel” to go back to the
previous menu option without formatting the memory.
