P&E CYCLONE FX, Руководство пользователя

Страница: 11 / 139

User Manual For CYCLONE FX Programmers 6
Figure 3-2: CYCLONE FX Right Side View
3.5 Cyclone System Power
The CYCLONE FX programmer requires a regulated 6V DC Center Positive power supply with
2.5/5.5mm female plug. Cyclones derive power from the Power Jack located on the right end of the
unit. The location of Cyclone System Power is shown in
Figure 3-2 .
3.6 RS232 Communication (Serial Port)
The CYCLONE FX provides a DB9 Female connector to communicate with a host computer
through the RS232 communication (115200 Baud, 8 Data bits, No parity, 1 Stop bit). The location
of the Serial Port is shown in
Figure 3-2 .
3.7 Ethernet Communication
The CYCLONE FX provides a standard RJ45 socket to communicate with a host computer
through the Ethernet Port (10/100 BaseT). The location of the Ethernet Port is shown in Figure 3-
2 .
3.8 USB Communications
The CYCLONE FX provides a USB connector for Universal Serial Bus communications between
the Cyclone and the host computer. The CYCLONE FX is a USB 2.0 Full-Speed compliant device.
The location of the USB Port is shown in Figure 3-2 .
3.9 Electromechanical Relays
Inside the CYCLONE FX programmer, two electromechanical relays are used to cycle target
power. The specifications of the relays are as following:
Maximum switched power: 30W or 125 VA
Maximum switched current: 1A
Maximum switched voltage: 150VDC or 300VAC
UL Rating: 1A at 30 VDC
1A at 125 VAC
PEmicro only recommends switching DC voltages up to 24 Volts.