Pace PROGRAMMABLE THERMOFLO, Руководство по эксплуатации и техническому обслуживанию

Страница: 48 / 92

43
OPERATION
Figure 46.
14. At the end of the cycle, gently lift the handpiece to
remove the component from the PCB. When using a
Single Jet nozzle, use a vacuum pickup device or
tweezers to lift the component from the PCB.
15. Position the component over a heat resistant surface.
16. Depress and hold the Vacuum Pick Switch for 0.5
second (minimum) to deactivate vacuum and release
component.
13. The Digital Readout will display the actual air
temperature (as it exits the heater) and the remaining
cycle (“Reflo”) time counting down. At 5 seconds
before the end of cycle, the vacuum will
automatically activate.
WARNING
The component is HOT! DO NOT remove or catch the component with
bare hands. Allow the component to drop onto the heat resistant surface.
Allow sufficient time for the component and PCB to cool to room temperature
before handling.