Pace PROGRAMMABLE THERMOFLO, Руководство по эксплуатации и техническому обслуживанию

Страница: 9 / 92

4
GENERAL INFORMATION
PRODUCT APPLICATION
This product is very versatile and may be used to satisfy a variety of application requirements. If you require
assistance in the use of this product in your particular application, contact your local authorized PACE distributor
or call PACE Product Management at Tel. (301) 490-9860, FAX (301) 604-8782.
PARTS IDENTIFICATION
FRONT PANEL
1. CYCLE LIGHT - LED flashes Green when air flow cycle is on.
2. VACUUM LIGHT - LED illuminates Red when vacuum is on.
3. MANUAL MODE LIGHT - LED illuminates Red when unit is in the Manual mode of operation.
4. TIMED MODE REMOVE LIGHT - LED illuminates Red when unit is in the Timed Remove mode
of operation. Also illuminates in Program Mode if selected profile is a removal process.
5. TIMED MODE INSTALL LIGHT - LED illuminates Red when unit is in the Timed Install mode
of operation. Also illuminates in Program Mode if selected profile is an installation process.
6. PROGRAM MODE LIGHT - LED illuminates Red when unit is in the Program mode of operation.
7. CYCLE KEY - Starts air flow through the heater initiating the reflow cycle in Manual and Timed
Modes and deactivates the air flow when pushed during a reflow cycle. Also initiates selected
rework Profile when in Program Mode.
8. TEMPERATURE SCROLL UP KEY - Increases the Set Temperature in one, then ten degree (if
key is held down) increments.
9. TEMPERATURE SCROLL DOWN KEY - Decreases the Set Temperature in one, then ten degree
(if key is held down) increments.
10. BLOWER SPEED SCROLL UP KEY - Increases the blower speed in increments of one.
11. BLOWER SPEED SCROLL DOWN KEY - Decreases the blower speed in increments of one.
12. CYCLE TIME SCROLL UP KEY - Increases the cycle time in one, then ten second (if key is held
down) increments.
13. CYCLE TIME SCROLL DOWN KEY - Decreases the cycle time in one, then ten second (if key is
held down) increments.
14. PROGRAM KEYPAD - Allows entry of process control parameters and selection of up to 80 user-
defined process control profiles. Individual key functions are:
a) Numbered Keys - Allow entry of numerical parameters plus profile selection in Program Mode.
b) 1/YES & 3/NO Keys - Allows entry of numerical parameters, profile selection and Yes or No
answers to Digital Readout questions when in the Program Mode.
c) EDIT Key - Allows editing of current profile displayed on Digital Readout.