Pace PROGRAMMABLE THERMOFLO, Руководство по эксплуатации и техническому обслуживанию

Страница: 54 / 92

49
OPERATION
Figure 54.
Figure 55.
16. If using a Single Jet nozzle in a hand held operation,
move the handpiece as necessary to direct air flow to
the solder areas requiring reflow.
17. The Digital Readout will display the actual air
temperature (as it exits the heater) and the remaining
cycle Reflow (“Reflo”) time counting down. At 5
seconds before the end of cycle, the vacuum (if
activated in step 8) will automatically terminate and
release the component and 5 beep noises will sound
until the cycle ends.
18. When cycle is complete, lift the handpiece from the
PCB.