Pace PROGRAMMABLE THERMOFLO, Руководство по эксплуатации и техническому обслуживанию

Страница: 64 / 92

59
OPERATION
Figure 72.
2. The Digital Readout will now display a stored profile
number or “Profile = - -” plus the component type
and number of solder connections. You can simply
press and release the EDIT Key to edit a profile
or
a) Press and release the RECALL Key (display will
read “Recall - -”)
b) Enter the desired profile number
c) Press and release the ENTER Key then the EDIT
Key.
NOTE
If the program number you have entered does not contain a stored profile,
"No Profile In Memory" will be displayed. Simplyselect a stored profile
number, then press and release the RECALL Key to try again. Press and
release the EDIT Key.
If "Save Cur Profile?" is displayed, press and release the NO Key then
press and release the EDIT Key. Take note of the profile number
displayed on the Digital Readout. This number reference is important
when performing step 29 of this procedure.
3. When in the Program Mode, either the Timed Mode
Remove Light or Timed Mode Install Light will be
illuminated and the Digital Readout will display a
corresponding message. If this is the type of profile
(Removal or Installation) you wish to store, press and
release the YES Key. If not, press and release the NO
Key to obtain the correct display for your profile, then
press and release the YES Key.
NOTE
Whenever the “Yes or No? question is displayed, the STEP key may also
be pressed and released (in the same manner as the YES Key) to move
to the next step of profile storage.
Figure 73.