Pace PROGRAMMABLE THERMOFLO, Руководство по эксплуатации и техническому обслуживанию

Страница: 46 / 92

41
OPERATION
9. Hold the handpiece vertical to the PCB.
8. Adjust the vacuum cup to a point where the bottom of
the vacuum cup is approximately flush with the bottom
edge of the nozzle using the Vacuum Pick Adjust
Control.
Figure 42.
Figure 41.
NOTE
Any required preheating should be completed before advancing beyond
this point.
7. If using a Single Jet nozzle, proceed to step 11.
4. Adjust the Set Temp as desired using the Temperature Scroll Up and
Down keys. Press and hold the key; observe the Digital Readout as the
Set Temperature increases (or decreases) in 1° and then 10° increments as
the key is held.
5. Adjust the Blower Speed (1-9) as desired using the Blower Speed Scroll
Up and Down keys.
6. Adjust the Cycle Time as desired using the Cycle Time Scroll Up and
Down keys. Press and hold the key; observe the Digital Readout as the
Set Temperature increase (or decrease) in 1 second and then 10 second
increments as the key is held.