ORTE Pellet Comfort 10, Техническая и эксплуатационная документация, руководство по эксплуатации и обслуживанию, гарантия

Страница: 20 / 39

www.orte.pl
www.orte.pl
Page | 20
A and B. Heating circuit supply connections (optional). Hot water outlet.
C. Exhaust output.
D. Drain hole.
E. Return water connection. Cold/cooling water inflow.
DANGER: Injury and/or damage to the system due to overheating!

The boiler can operate only with an active thermal outflow protection and/or safety heat
exchanger.

Always ensure that cooling water is supplied to the thermal outflow protection and safety heat
exchanger to maintain the required water pressure.

Inform the user about the operation of the thermal outflow protection and safety heat
exchanger.
DANGER: Danger to health due to contamination of usable water!

Ensure compliance with national regulations and standards on the prevention of usable water
contamination (e.g. water from heating systems).

Ensure compliance with EN 1717.

Put a filter in the cooling water inlet, in front of the thermostatic valve.

Do not place mountings allowing for the total or partial closure of the flow or devices and
mountings reducing the internal cross-section on safety pipes, expansion pipe, overflow pipe and
venting pipe.
INFO: The minimum capacity of the expansion vessel is calculated according to the formula [1] - PN-91/B-
02413 p. 2.5.1.
INFO: Equipment and placement of the expansion vessel is determined by PN-91/B-02413 p. 2.5.2.÷2.5.4.
Expansion vessel, safety pipes, expansion pipe, signal pipe and overflow pipe must be at a place where the
air temperature is not lower than 0 ° C.
INFO: If the expansion vessel is at a place where the air temperature drops below 0°C, use circulation
pipes and safety pipes connecting the expansion vessel with the boiler, as well as thermal insulation
according to PN-91/B-02413 p. 2.11. Thermal insulation of safety devices is to protect them against
freezing only during short interruptions of heating.
NOTE! – The lack of thermal insulation and placing the expansion vessel not in accordance with PN-91/B-
02413 identified during warranty claims for leaks during temperature drops below 0°C
can be grounds for not accepting the complaint and refusing to repair or replace the boiler.