ORTE Pellet Comfort 10, Техническая и эксплуатационная документация, руководство по эксплуатации и обслуживанию, гарантия

Страница: 27 / 39

www.orte.pl
www.orte.pl
Page | 27
7.6. Burner trouble
In case of any irregularities, try to recognize the fault by using the table below or contact the service
technician.
No. Fault Presumed cause Solution
1.
the burner does not
ignite
no fuel in the tray – NO FUEL
message appears
- add fuel (pellet)
delete the message on the display by pressing STOP
- restart by pressing START
damaged burner contact the service
slag in the fireplace
- thoroughly clean the fireplace
- clear air holes
the burner, stocker and
feeder do not work
replace the fuse located near the controller (fuse 5A – 5x20)
2.
the fan does not turn
on when putting out
the burner
damaged fuse
contact the service
change fuse
3.
feeder ignition alarm
– AUGER IGNITION
TEMPERATURE
excessive temperature rise of
the burner housing caused by
the burner ignition in the
stoker tee or the backfill pipe
- when the controller finishes putting out (the fan will turn off
and the stoker will turn on to remove the remaining fuel), wait
until the burner housing temperature drops
delete the message on the display by pressing STOP
- restart by pressing START
4.
boiler overheating
alarm – BOILER
OVERHEATING
message appears
water temperature exceeded
in the boiler (temperature set
by the technician)
- wait until the temperature in the boiler drops below the alarm
level
delete the message on the display by pressing STOP
- restart by pressing START
5.
damaged
temperature sensors
damaged sensor circuit or the
temperature
outside the
measurement range -9°C -
109°C
- press STOP
- if the message is not removed after pressing STOP, contact
the service technician
damaged circuit of the burner
temperature sensor (feeder)
damaged circuit of the central
usable water heating system
sensor turns on the usable
water heating system
adjustment
contact the service
damaged burner temperature
sensor
6. the burner produces
smoke
soot is produced - too much fuel (pellet) is feed
in relation to air
- dirty burner fireplace
- slag in the fireplace - thoroughly clean the fireplace
- clear air holes
- adjust the burner - fuel and air for max. and min. power
7.
slag is too often
produced in the
fireplace - the burner
does not clean itself
improper fuel change pellet