ORTE Pellet Comfort 10, Техническая и эксплуатационная документация, руководство по эксплуатации и обслуживанию, гарантия

Страница: 28 / 39

www.orte.pl
www.orte.pl
Page | 28
7.7. Replacement of spare parts in the burner
REMEMBER!!! IF YOU WANT TO TURN OFF THE DEVICE – USE THE STOP BUTTON ON THE
CONTROL PANEL. DO NOT UNPLUG IT BECAUSE OF THE RISK OF EXPLOSION.
DANGER: Before cleaning the device, make sure that it is unplugged and that it has been turned off for at
least 3 hours.
7.7.1. Replacement of the lighter
Turn of the burner by pressing STOP. After the fan turns off (after 10-30 minutes, depending on the
settings), unplug the device, unscrew the powder coated cover (cap), unscrew the burner cover (part with
motoreducer). Below the tee, there is a metal pipe with three glass pipes inside – this is the lighter. Unplug
the lighter from the connection block and make sure that it is not hot (touching the hot burner may cause
injuries). Firmly grasp the lighter and remove it from the slot. Insert a functioning lighter. Make sure that it
is pressed against the fireplace plate. Otherwise, there may be issues with burning. If the lighter is not
firmly pressed, it does not heat pellet sufficiently and does not initiate ignition. The used part should be
return to a collection point or sent back to the manufacturer.
7.7.2. Replacement of the photoelement
Turn of the burner by pressing STOP. After the fan turns off (after 10-30 minutes, depending on the
settings), unplug the device and unscrew the powder coated cover (cap). In the burner cover (silver part
with motoreducer installed in the central part), on the right side, there is a rubber cover. Remove it and
unplug the cable going from the connection block. The cable entering the rubber cover has a
photoelement at the end. Remove the damaged part from the rubber cover and mount a new
photoelement. The used part should be return to a collection point or sent back to the manufacturer.
8. MAINTENANCE
Why regular maintenance is important?
Due to the following reasons, you should regularly perform maintenance of the heating system:
• in order to maintain high efficiency of the system and ensure economic fuel use,
• in order to ensure operational safety,
• in order to ensure that the combustion process is friendly for the environment.
The Pellet Comfort device requires the removal of ash. The amount of ash depends on the quality of pellet,
time of operation and the size of the burner. In order to facilitate the removal of ash, you may use the rake
(added to the boiler). Once a month, it is recommended to unscrew the burner and remove ash from the
burner and the combustion chamber.