Omron F3SG-RA, Руководство пользователя

Страница: 223 / 268

199
F3SG-R
User’s Manual
Ch
apt
e
r
5
Wir
ing
Ex
amples
(F3
S
G-
RA
Series
)
Input/Output Circuit and Applications
E
5-2-2-4. Standard Muting Mode with four Muting Sensors using PNP Outputs
The following is the example of External Device Monitoring disabled, Auto Reset mode, PNP output
and External Test in 24 V Active.
[DIP Switch settings] *5
 : Indicates a switch position.
Configure functions with the DIP Switches before wiring.
[Wiring Example]
Function DIP-SW1 DIP-SW2
Receiver
EDM Disabled (factory default setting)
Auto Reset (factory default setting)
PNP (factory default setting)
Emitter External Test: 24 V Active (factory default setting)
㻞 㻻㻺 㻞 㻻㻺
㻟 㻻㻺 㻟 㻻㻺
㻠 㻻㻺 㻠 㻻㻺
㻣 㻻㻺 㻣 㻻㻺
㻠 㻻㻺
OSSD1 : Bla
ck
OSSD2 : White 2
4
VD
C
: Br
own
Not used : Yell
ow
TEST : Bla
c
k
Not used : W
h
ite
2
4
VD
C
: Br
own
0 VDC : Blu
e
Receiver
Emitter
0 V
D
C : B
lu
e
AU
X : Red
MUTE B
: Pink
MUTE A
: Gray
RE
SET : Yell
ow
*1
S1: Test Switch (Connect the line to 0 V if this
switch is not required)
S2: Lockout/Interlock Reset Switch,
Override Switch or Override Cancel Switch
A1, A2, B1, B2: Muting sensor
S1
S2
*2
Muting
Sensor
(PNP
output)
Reflector
F3SG
F3SG
A1 A2
B1
B2
Power Supply
+24 VDC
0 VDC
Safety
Controller *3 *4
IN1 IN2
Unblocked
Blocked
MUTE A
Beam state
MUTE B
OSSD
Test Switch (S1)
F39-JG A-L F39-JG A-D
PLC *6
IN
*1. Also used as Override input line.
*2. Make sure to connect an override cancel switch to the Reset line when
using the override function. Otherwise the override state may not be
released by the override cancel switch, resulting in serious injury.
*3.Refer to 5-4. Connectable Safety Control Units for more information.
*4.The safety controller and the F3SG-R must share the power supply or
be connected to the common terminal of the power supply.
*5. The functions are configurable with DIP Switch. Refer to Chapter 3
Setting with DIP Switch for more information on setting the functions
by the DIP Switch.
*6. When connecting to the PLC, the output mode must be changed with
the Configuration Tool according to your application.