Omron EQ100-E, Руководство пользователя

Страница: 67 / 256

5. Installation and Wiring
5-1
Installation and Wiring 5.
5.1. Precautions on Installation
Installation must take into the following items into account for higher authenticity and
performance of EQ100.
■
Installation Location
For installation, avoid the locations:
・
subject to large vibration or shock impact
・
subject to direct sunlight, wind, or rain, or outdoors
・
where temperature or humidity is out of the specified range
・
subject to large changes of temperature or humidity, or potential dew condensation or freezing
・
subject to static electricity or noise
・
subject to corrosive gases (especially sulfide or ammonia gas)
・
subject to heavy dust or iron powder
・
subject to water splashing or oil contact
・
subject to salt water splashing
■
Mounting
For main body heat radiation, only the following installation is allowed.
Do not install in a way as shown below.
- Do not block the ventilations holes and the peripheral areas. It may obstruct heat radiation.
- For heat radiation, keep spaces of 30mm or more for the top and bottom of this product.
- Do not place the product close to heat radiating equipment (e.g. heater, transformer,
high-capacity resistor).
Top
Top