Omron DeviceNet Safety, Руководство по настройке системы

Страница: 175 / 376

141
Local I/O Settings Section 5-5
Note Can be selected only when the terminal number is an even number.
• The following dialog box will be displayed if a type with welding check is
selected when the terminal is set.
• In this dialog box, select the input for which welding is to be checked, and
then click the OK Button.
3. Click the Next Button.
The window for setting input terminals will be displayed.
4. In the above window, specify the type of device to be connected to each
terminal. The following types can be specified.
Other Standard Output Specify to use the output for non-safety
applications.
Not Use Specify to not use the output.
Type Description
Type Description
EM0 2b (DPST-NC, see note 1.) Specify to connect two inputs from an emergency OFF button.
EM0 1b (SPST-NC) Specify to use one input from an emergency OFF button.
Door SW 2NC (See note 1.) Specify to use two inputs (NC) from a door switch.
Door SW 1NC/1NO (See note 1.) Specify to use two inputs (NC and NO) from a door switch.
Door SW 1NC Specify to use one input from a door switch.
Limit SW 2NC (See note 1.) Specify to use two inputs (both NC) from a limit switch.
Limit SW 1NC/1NO (See note 1.) Specify to use two inputs (NC and NO) from a limit switch.
Limit SW 1NC Specify to use one input from a limit switch.
Enable SW 2NO (See note 1.) Specify to use two inputs from an enable switch.
Enable 2NO 2NO (See note 2.) Specify to use four inputs from an enable switch.
Other 2NC (See note 1.) Specify to use input from other 2-NC devices.
Other 2NO (See note 1.) Specify to use input from other 2-NO devices.
Other 1NC/1NO (See note 1.) Specify to use input from other NC/NO devices.
Other 1NC Specify to use other 1-NC devices.
SLC 2 outputs (See note 1.) Specify to use two inputs from a light curtain.