Omron DeviceNet Safety, Руководство по настройке системы

Страница: 139 / 376

105
Editing Parameters for Logic Terminals (DST1-XD0808SL-1) Section 4-2
1. Terminal No.
Displays the terminal number being used. If a device with two inputs is se-
lected at the Input Bits Dialog Box, the corresponding two inputs will be dis-
played (e.g., IN0/IN1).
2. Terminal Name
The comment that was set in the Input I/O Comment Dialog box will be dis-
played.
3. Input Function Block
The function block selected in the Input Bits Dialog Box will be displayed
automatically. If a device with two inputs is selected, two inputs will be used
for the function block (e.g., If EM0 2b is selected, IN0/IN1 will be used).
4. Input Conditions
(Refer to Selecting Input Conditions )
5. Reset Conditions
(Refer to Selecting Reset Conditions )
6. Safety Input Logic Configuration Results
These are the terminal names that are used for the output logic.
The terminal names are automatically set by the wizard.
To change them, set the Safety Logic Comments in the Parameters Dialog
Box.
Use the following procedure for the Input Dialog Box for the Safety Logic Wiz-
ard.
Selecting Input Conditions
Use the following procedure to select the input conditions.
1,2,3... 1. Click the selection button shown in the following figure.
The following options will be displayed.
2. Select the desired input condition.
The options are as follows:
(1) No Input Condition
Input condition is not specified.
(1)
(2)
(3)