Omron CX-Process Monitor Plus 2, Руководство по эксплуатации

Страница: 242 / 272

227
Checking Configurations Section 5-7
Note (a) PLC network address, node address, and Unit address commu-
nications are based upon the settings made using the CX-Pro-
cess Tool (select
Settings , Network Settings ). (Set the node
address and Unit address using the System Monitor Settings
Window to use the System Monitor Screen).
(b) If using Controller Link or Ethernet, you must start FinsGateway
communications manually. (Set Controller Link and Ethernet
communications type using the System Monitor Settings Window
to use the System Monitor Screen).
5. The Overview Screen will be displayed as shown in Section 4-5 Overview
Screen . Check to make sure that screens selected and set in the Overview
Screen are operating correctly. For details on individual screens, refer to
the sections from
4-7 onwards.
5-7-2 Setting the Auto-start Function
1,2,3... 1. Click the System Info. Button in the Setup Dialog Box.
2. Select Auto-start.
3. Set Auto-start to Enable .
Note If the auto-start function is enabled, an Overview Screen will be displayed as
soon as the CX-Process is started. The auto-start setting can be disabled by
either of the following two methods.
• Double-click the MonitorCom.exe file from your Explorer to open the Sys-
tem Information settings and disable auto-starting under the Auto-start
settings.
• Click the right mouse button at the top of an Overview Display and then
click the Yes Button on the dialog box that will appear to open the System
Information settings. Disable auto-starting under the
Auto-start settings.
5-7-3 Ending the Monitor Process
1,2,3... 1. Click the Close Button in the upper right corner of the Overview Screen.
2. If a monitor process such as data collection or trend collection is in
progress, a dialog box will be displayed to confirm that the monitor process
is to be ended. Click the
Yes Button.
3. The monitor process will be ended.