![background image](http://html1.mh-extra.com/html/omega/cl3001/cl3001_user-manual_737625020.webp)
3. Getting Started
After unpacking the CL3001 and becoming familiar with the layout
and general operation of the unit as described in the previous
section, it is ready to set up for operation.
The following steps should be followed to set up the CL3001 for
operation:
a)
Before
attaching the power cord to the rear connector, check
that the line voltage selector is set appropriately for your location.
The CL3001 is shipped from the factory with the line voltage set
for the country of purchase. To verify the line voltage setting,
check the indicator on the power line voltage selector and fuse
compartment cover; see figure 5 in section 2.5 for the location.
Confirm that the setting is correct according to the following
guidelines:
Line Voltage (50/60Hz)
Selector Position
90 to 135 VAC
120 VAC position
220 to 250 VAC
240 VAC position
If the setting is not correct, follow the instructions in section 11.3 to
change it.
b) Once the voltage selection has been made, making sure that the
power switch is off, connect the AC power cord to the CL3001;
see figure 5 in section 2.5 for the location.
c) Turn on the CL3001 using the rear panel mounted rocker switch.
The CL3001 should power up within a few seconds, briefly
displaying the model number and firmware version in the
primary display before reverting to the normal input/output
display.
NOTE
:
If a proper power up display does not occur within 30
seconds, turn the power off, wait a few seconds, and repower the
unit. If the problem persists, report the problem to Omega
immediately.
Warm up time is twice the time since last warmed up, to a maximum
of 30 minutes. For good stability it is best to leave the CL3001 on all
the time.
4. Primary Inputs and Outputs
4.1 DC Voltage Output
The CL3001 can source DC voltages from 0 V to 100 V, using the
following four ranges for maximum accuracy: .1 V, 1 V, 10 V, and 100 V.
16
Содержание CL3001
Страница 103: ......