USE AND CARE GUIDE
WELL LIGHT
MODEL # NEB-LSP-0007
A
Light Body (1)
B
Connector Clip (1)
1. Preparation
• Before beginning assembly, compare parts with package
contents list to make sure all are present. If any part is
missing or damaged, do not attempt to assemble the
product.
• Estimated installation time: 10-15 minutes.
• No Tools Required for Assembly.
2. Installation
• Determine the location of your light. Dig a small hole
in the ground with a trowel.
• Press the light body into the hole until the light is secure, but
can still be adjusted.
• Dig a small trench from the light to the transformer wire.
• Secure the connector clip (B) to the transformer wire, as
shown above.
• Test the connection by turning on the lights. Make any
desired adjustments.
• Secure the light in the ground and fill in the trenches
with dirt.
A
ASSEMBLY AND INSTALLATION
WARNING:
Never use a hammer to insert the light into the ground.
WARNING:
The wire connector (B) contacts have sharp edges for piercing the
main low voltage cable. To avoid injury, do not touch the metal contacts.
CAUTION:
The wire from low voltage power unit should be 12-18 AWG type
underground Low Energy Circuit Cable.
IMPORTANT:
• Do not submerge the fixture in water.
• Do not install the fixture within
10 ft. of water.
•
The landscape wire can also be
hidden under surface.
•
Protect the wiring by routing it in
close proximity to the light fixture,
or next to a building structure.
(Power Pack Sold Separately)
B
