Oliver 4065, Руководство пользователя, Страница: 63 / 88

4065 Table Saw OLIVERMACHINERY.NET 63 | Page
Operation Issues
Problem Possible Cause Solution
Kickback. Not using any anti-
kickback devices.
Whenever possible, use the blade guard or
riving knife when cutting with a table saw.
Making cross cuts with a
miter gauge and using a
fence to set the length
of the cut.
Remove the fence when using a miter gauge
for cross-cuts.
Fence is not aligned with
the blade.
Adjust fence alignment.
Riving knife/spreader is
not aligned with the
blade.
Adjust riving knife/spreader alignment.
Cutting warped/unstable
stock.
A warped workpiece should be flattened and
have at least one edge straightened before
being cut with a table saw. A slightly cupped
board should have the cupped side facing
down to improve stability when feeding.
Improper feeding
techniques.
Never rotate the workpiece into the back side
of the blade when feeding.
Saw dust escape and
blow toward the
operator.
Dust collection system is
not operational or
underpowered.
Ensure the dust collection system is turned on
and has significant suction. Unclog dust shroud
and hose, and seal leaks in the dust collection
system.
Blade guard not
installed.
Install the blade guard.
Dust shroud is clogged. Remove dust accumulated inside the dust
shroud.
Workpiece catches the
table insert when
feeding.
Table insert is not flush
with the table.
Adjust the height of the table insert so all
edges are flush with the table.
Incorrect reading on the
digital readout.
The digital readout was
not zeroed.
Re-zero the digital readout for blade height
while the blade dips right below the table.
Re-zero the blade tilt reading with a
machinist’s square.