
30 |
Page
Oliver Machinery
4065 Table Saw
Fence Setup
1.
Install the fence handle.
2.
Mount the fence onto the front rail.
3.
Make sure the fence aligns with the miter
slot. Using a dial indicator with a miter slot
compatible base to check the alignment will
result in a more accurate measurement.
4.
If a dial indicator is not available, check the
alignment using a combination square.
5.
Refer to “Fence to Miter Slot Alignment” on
page 49
for details about checking and
readjusting the fence to miter slot alignment.
6.
Use a square to verify the fence face is
perpendicular to the table. Refer to “Fence
Squareness Adjustment” on page 50 if
adjustment is needed.
7.
The fence should flow on top of the cast iron
table and only be supported by the front rail
and the glide plate near the rear of the fence.
Use a feeler gauge or a piece of cardboard to
make sure there is a gap of approximately
1/16” between the fence face and the table.
Refer to “Fence Height Adjustment” on page
50 if adjustment is needed.
Содержание 4065
