Oliver 4065, Руководство пользователя, Страница: 22 / 88

22 |
Page Oliver Machinery 4065 Table Saw
Leveling Main Unit
The cast iron tabletop of the saw should be level with the
floor. This makes it easier to extend the saw table and set
up auxiliary support devices when needed. After the saw
main unit is situated at its designated location, lower the
anti-vibration leveling feet by turning the red dial
counterclockwise. Adjust the leveling feet until the saw
table is level with the floor and the main unit is not
rocking on the floor. The saw must stay stationary while
it is in use.
Essential Mechanical Inspections Before Assembly
This table saw has been tested and calibrated before leaving the manufacturing facility. It should not
require extensive adjustments. The essential checks provide an opportunity to get familiarized with the
saw, and it helps to discover any potential issues before the final assembly.
If issues were found from the inspections, please refer to “Maintenance” on page 55 and “Troubleshooting”
on page 61 to correct the issues.
WARNING
Disconnect the table saw from the power
source before inspection! Failure to do so
can result in serious injuries.
CAUTION
The inspection involves moving the saw
blade. Wear thick leather gloves to prevent
injuries from accidental blade contact.
Remove the gloves before operating the
saw.