Oliver 4065, Руководство пользователя, Страница: 40 / 88

40 |
Page Oliver Machinery 4065 Table Saw
Swapping Riving Knife / Blade Guard
This table saw is equipped with a blade guard
and a riving knife. These anti-kickback devices
significantly reduce the chance of kickback
accidents. Unless for making a dado cut, one of
these devices should be mounted for operations.
1. Disconnect the saw from the power source.
2. Unlock and remove the table insert.
3. Raise the blade to the maximum height and
set the blade tilt to 0°.
4. Loosen the mounting bolt to swap the riving
knife/spreader.
5. When installing a different anti-kickback
device, make sure the pins on the mounting
bracket fit through the holes of the device
installed. Tighten the mounting bolt to
secure the device.
6. Reinstall the table insert.
Using the Digital Readout
This table saw comes with digital blade elevation
and blade tilt readout:
•
To reset the blade height indicator to zero.
Short press the “set 0” button.
•
To reset the blade tilt indicator to zero. Hold
the “set 0” button until the value is reset.
•
The negative value indicator lights up when
the blade height value is negative.
•
NOTE : All values will reset to zero when the
saw disconnects from power.