
50 |
Page
Oliver Machinery
4065 Table Saw
Fence Squareness Adjustment
1.
The fence face should be perpendicular to
the cast iron table. Check the squareness of
the fence with a machinist square.
2.
To adjust the squareness of the fence, adjust
the two nylon set screws on the fence
bracket until the fence face is perpendicular
to the table.
3.
After the adjustment, check the height and
levelness of the fence. Make sure the fence
is elevated approximately 1/16” above the
table.
Fence Height Adjustment
1.
There should be a 1/16” gap between the
fence face and the table. The gap allows the
fence to slide freely and not scratch the table.
If the gap is too big, or if the fence is
scratching the table, or if the fence is not
level from front to rear, adjustment is
needed.
2.
To adjust the height of the fence in the front,
make the same amount of adjustments on
both nylon set screws.
3.
The fence in the rear is supported by a fixed-
height glide pad. Replace the glide pad when
it is worn or damaged.
Содержание 4065
