Oliver 4065, Руководство пользователя, Страница: 39 / 88

4065 Table Saw OLIVERMACHINERY.NET
39 |
Page
Changing Saw Blade
CAUTION
Please wear thick gloves to protect your
hands when changing saw blades. The saw
blade teeth are sharp and can easily cut
through the skin when not protected.
1. Disconnect the saw from the power source.
2. Unlock and remove the table insert.
3. Raise the blade to the maximum height and
set the blade tilt to 0°.
4. While standing in front of the table saw, take
one arbor wrench and insert it into the slot
on the left side of the blade. Rotate the arbor
until the wrench catches the arbor.
5. Hold the wrench in the left hand to stop the
arbor from rotating, then loosen the arbor
nut with the wrench in the right hand. Pull
the wrench towards the front of the saw
(rotate counterclockwise) to loosen the nut.
6. Remove the arbor nut, flange, and blade.
Handle the blade carefully to prevent
injuries.
7. Install the saw blade of choice. Pay attention
to the orientation of the blade teeth. Do not
install the blade in reverse.
8. Install the flange. Make sure the wider base
is facing the blade.
9. Install and tighten the arbor nut with the
arbor wrenches.
IMPORTANT
Do not over tighten the arbor nut, as it is self-
tightening. Over-tightening the nut will make
it difficult to remove in the future, and it can
also damage the saw.
10. Reinstall the table insert and blade guard
after changing the saw blade.