
54 |
Page
Oliver Machinery
4065 Table Saw
Spreader/Riving Knife Mounting Bracket Alignment Adjustment
The spreader/riving knife alignment was calibrated in the factory and should not require further
adjustments. If a riving knife or spreader is not aligned with the blade, make sure it is not bent. Follow the
steps below if the mounting bracket needs an adjustment.
1.
Disconnect the saw from the power source.
2.
Wear thick leather gloves for this procedure,
as the calibration work will be done next to
the saw blade.
3.
Remove the table insert.
4.
Raise the saw blade to maximum height.
5.
Use the arbor wrench to loosen the
mounting
nut and remove the
spreader/riving knife.
6.
Loosen up the two hex cap screws on the
bracket.
7.
Adjusting the top/bottom pair of set screws
will cause the riving knife to roll left or right
along the horizontal axis. Adjusting the
left/right pair of set screws will cause the
riving knife to rotate along the vertical axis.
Make the same amount of small
adjustments on the pair of set screws.
8.
Tighten the cap screws and reinstall the
riving knife to test the adjustment.
9.
Repeat steps [5-8] until the riving knife aligns
with the blade and stays within the
“alignment zone”.
10.
Reinstall the table insert and remove gloves
before cutting with the table saw.
Содержание 4065
