Oliver 4065, Руководство пользователя, Страница: 61 / 88

4065 Table Saw OLIVERMACHINERY.NET 61 | Page
Troubleshooting
Mechanical / Electrical Issues
Problem Possible Cause Solution
Machine does not start.
Not connected to a
power source.
Make sure the machine is plugged in.
Check the electrical panel for a tripped circuit
breaker or a blown fuse.
Ensure all electrical connections have good
contacts.
The saw was overloaded,
and thermal protection
was triggered.
Wait for at least 1 minute for the motor to cool
down and the thermal relay to reset
automatically before restarting the saw.
Low voltage/current. Have a licensed electrician check/repair the
power circuit.
Power switch is locked. Use the provided key to unlock the saw. Turn
the key to “ON” position.
Faulty switch/motor/
capacitor.
Contact customer service for further
assistance.
Machine stalls or does
not come up to speed.
Extension cord is too
light or too long.
Use a shorter / heavier cord that meets this
machine’s electrical requirements.
Feeding rate is too high. Reduce feed rate.
Dull blade or wrong
blade for the cut.
Use a sharp, clean blade that is designed for
the type of cut.
Feeding stock with the
blade installed
backwards.
Reinstall the blade the correct way.
Ripping crooked stock. Straighten the fence-facing edge of a
workpiece before the rip cut. Avoid ripping
unstable stock.
Stock binding between
the blade and the fence.
Ensure both the saw blade and the fence align
with the miter slot. Adjust alignment as
needed.
Belt slipping Clean belt and pulleys. Check/adjust belt
tension and make sure the belt is seated
properly.
Motor is not wired
properly for the
operating voltage.
Use the wiring diagram to properly wire up the
motor.
Motor/capacitor issue. Contact customer service for further
assistance.