Oliver 4065, Руководство пользователя, Страница: 42 / 88

42 |
Page Oliver Machinery 4065 Table Saw
6. Before starting the saw, make sure the blade
is not in contact with the workpiece or any
guides or guards.
7. Remove pencils, measuring tape, and other
items from the table before starting the saw.
8. Turn on the dust collection device and start
the saw.
9. Begin the rip cut by holding the workpiece
firmly against the fence and the table surface.
Feed the workpiece towards the blade. Stay
alert and maintain a steady feed rate.
10. When cutting a small workpiece, the hand
can get close to the saw blade. In this case,
use a push stick to finish the cut.
11. When feeding a workpiece with a push stick,
position the push stick close to the blade.
Doing so prevents the workpiece from rolling
into the blade and kicking back toward the
operator.
12. Keep feeding the workpiece until it clears the
blade guard or riving knife, then turn off the
saw. Wait for the blade to come to a
complete stop before retrieving the
workpiece.
13. To prevent kickback, never back out a cut
while the blade is still spinning. If it is
necessary to stop a cut in the middle of the
process, stop the saw and wait until the
blade comes to a complete stop, then
remove the workpiece.