
60 |
Page
Oliver Machinery
4065 Table Saw
11.
To minimize tear-outs, the zero clearance
table inserts should be cut for a specific
blade tilt angle. If the insert needs to be used
for the entire range of blade tilt, set the
blade angle to 45°, then repeat steps 7-10
with a new board supporting the table insert.
WARNING
Only the regular zero clearance table
insert (Part#
4065.A003
)
can be slotted
multiple times at different blade tilt
angles.
The dado insert can only be slotted
when the dado blades are
perpendicular to the table. Attempting
to slot the dado insert at a beveled
angle can destroy the dado insert and
may cause severe injuries.
WARNING
Slotting a homemade table insert at
different angles may create debris that
is large enough to get caught in
between the blade and the dust
shroud. The debris can become a high-
speed projectile when struck by the
blade. This hazardous situation can
cause serious injury to the operator
and damage the table saw.
12.
Disconnect the table saw from power after
setting up the table insert.
Содержание 4065
