
26 |
Page
Oliver Machinery
4065 Table Saw
Electrical Connection and Tests
After the table saw passes the essential mechanical inspections, refer to “Electricals” on page 14 and
“Wiring Diagrams” on page 65 to connect the table saw to the power source, then continue with the
tests below.
WARNING
This table saw is a heavy-duty, industrial-grade machine. The electrical work must
be completed by a licensed electrician and meet the local electrical code
requirements. Failure to comply can create lethal electrical and fire hazards and
void this machine’s warranty.
Test 5: Motor and Magnetic Switch Functionality
1.
Put on safety goggles and ear protection.
2.
Insert and turn the key to “ON” position.
3.
Reset the emergency stop button by rotating
it clockwise until it pops up.
4.
Press the green “START” button to turn on
the saw. The table saw should run smoothly
with minimum vibration.
5.
Press the emergency stop button. The blade
should gradually come to a stop. Observe
the rotation direction of the blade through
the table insert. Illuminate the blade with a
flashlight as needed. If the saw blade runs in
reverse, swap any two of the incoming hot
wires in the junction box. See “Electricals” on
page 14 and “Wiring Diagrams” on page 65
for details.
6.
Reset the emergency stop button and start
the saw again.
7.
Disconnect the saw from power. Wait for a
few seconds until the motor comes to a stop,
then reconnect the saw to power. The saw
should not start. The magnetic power switch
turns off automatically when the saw is
disconnected from power. The saw will only
turn on again when the operator presses the
“ON” button.
8.
Press “STOP” to turn off the saw. The motor
should come to a stop.
9.
Reset the emergency stop button and lock
the saw by turning the key to “OFF” position.
Press the START button, and the saw will not
start.
10.
Rotate the key to the “ON” position again
and press the START button, and the saw will
start.
11.
Press “STOP” to turn off the saw, then
disconnect the saw from power for assembly.
Содержание 4065
