
48 |
Page
Oliver Machinery
4065 Table Saw
Calibrations and Adjustments
Blade to Miter Slot Alignment
The blade to miter slot parallelism is calibrated
at the factory and should not require further
adjustments. The factory tolerance is 0.2mm
(approx. 0.008”). Check the blade to miter slot
alignment before calibrating the fence.
IMPORTANT
For the best result, measure the alignment
with a dial indicator mounted on a base that
can glide along the miter slot. It is also
possible to mount the dial indicator on the
miter gauge. Make sure there is no play
between all components. If a dial indicator is
not available, it is possible to measure with a
combination square or measuring tape.
However, the result can be less accurate.
CAUTION
This test involves moving the blade. Wear
thick leather gloves to prevent injuries from
accidental blade contact. Remove the gloves
before operating the saw.
1.
Disconnect the saw from the power source.
2.
Raise the blade to the maximum height and
set the blade tilt to 0°
3.
Mark the blade to set a reference point near
the edge of the saw blade.
4.
Move the reference point towards the front
of the saw, then position the dial indicator so
that its contact point rests on the reference
point. Set the dial indicator to zero.
5.
Move the reference point towards the rear
of the table, then slide the dial indicator to
the back so the dial indicator’s contact point
is again resting on the reference point.
6.
Take the measurement. If the offset is
greater than 0.2mm or 0.008”, rotate the
table to align the miter slot to the saw blade.
7.
There are four table mounting bolts located
at each
corner
of the cabinet. Loosen any
three of them with a wrench.
8.
Rotate the cast iron table in small
increments until the blade aligns with the
miter slot.
9.
Tighten all table mounting bolts. Repeat
steps [4-6] one more time to double check
the alignment.
IMPORTANT
If the table has to be shifted significantly to
align the miter slot, the zero clearance table
insert will need to be re-slotted or replaced.
Содержание 4065
