
4065 Table Saw
OLIVERMACHINERY.NET
59
|
Page
Table Insert Setup
1.
Install the table insert and adjust the six set
screws until the insert is flush with the table,
then rotate the lock knob clockwise to
secure the insert.
2.
NOTE
: The zero-clearance table inserts must
be cut before use. Please make sure the saw
is calibrated and the desired blade is
properly installed before cutting the insert.
3.
Before cutting the slot of the table insert,
make sure the insert is locked securely on
the table and the blade is lowered
completely.
4.
Put on protective gear.
5.
Connect the saw to a power source.
6.
Set the blade angle to 0°, so the blade is
perpendicular to the table.
7.
Clamp a piece of straight and thick wood
board on top of the insert where the slot will
be cut. Doing so ensures the insert stays in
place when it is cut and reduces the amount
of dust released.
8.
Turn on the dust collection system.
9.
Turn on the saw and slowly raise the blade
to its maximum height.
10.
Turn off the saw. Lower the blade
completely and remove the supporting
board and clamps.
Содержание 4065
