Nikon HQA46480, Инструкция по эксплуатации

Страница: 46 / 185

3 Getting Started
32 Total Station DTM-322 Instruction Manual
Press
[HOT]
to display the HOT menu. Then either press
[3]
, or select
Target
and press
[ENT] . A list of the five target sets appears. To select a target set, either press the
corresponding numeric key (
[1]
through
[5]
), or use
[^]
or
[v]
to highlight the target set in
the list and press [ENT] .
To change the settings defined in a target set, highlight
the target set in the list. Then press the
Edit
softkey.
Entering a field note
To enter a field note, press
[HOT]
to display the HOT
menu. Then either press
[4]
, or select
Note
and press
[ENT]
.
This function can be used at any time on any
observation screen.
Each note can be up to 50 characters.
The note is stored as a CO record in the raw data.
To display a list of previously used notes, press the
Stack
softkey. The stack stores the last 20 notes.
Use
[^]
or
[v]
to highlight a note in the list. Then press
[ENT]
to select the note.
Setting the default point name
To change the default point name, press
[HOT]
to display
the HOT menu. Then press [5] , or select
Default PT
and press
[ENT]
.
This function is available from any observation screen.
Type Prism / Sheet
Const –999 to 999 mm
HT –9.9900 to 99.9900 m
HT can be left blank in the target set. If you leave it blank, the current HT value is always applied to the
measurement.
When a target set is selected, the Type and Const values are copied to both [MSR1] and [MSR2] settings, and to
the measurements in Qcode. If you have specified a value for HT, this value is also copied to the current HT.