NF WAVE FACTORY WF1967, Инструкция по эксплуатации

Страница: 294 / 330

17.4 Output Characteristics
WF1967/WF1968 17-4
17.3.2 Phase
Phase represents the phase of waveform output to the reference phase synchronization output
waveform. This does not include noise and DC.
Setting range of the phase (main-output) -1800.000° to +1800.000°(resolution 0.001°)
Common to the oscillation start/end phase of
the gated single sweep and burst
Setting range of the phase (sub-output/sub-waveform)
-180.000° to +180.000°(resolution 0.001°)
Reference phase synchronization output waveform A square wave with duty 50% rising at zero
degree of reference phase of the waveform
output. This can be output from the
synchronization/sub-output.
When the waveform is noise or DC, fixed to
low level.
17.4 Output Characteristics
It specified only to the main output except section 17.4.5.
17.4.1 Amplitude
Setting range 0Vp-p to 20Vp-p/open
0Vp-p to 10Vp-p/50
Ω
A peak value combining waveform amplitude and DC
offset is limited to ±10V/open or less.
With frequency exceeding 110MHz, the value combining
waveform amplitude and DC offset is limited to
±2V/open.
Setting resolution 999.9mVp-p or less 4 digits or 0.1mVp-p
1Vp-p or more 5 digits or 1mVp-p
Accuracy
*1
±(1% of Amplitude setting [Vp-p] + 2mVp-p)/open
Conditions: Continuous oscillation, 1kHz sine wave, load
open, amplitude setting 20mVp-p or more,
DC offset setting 0V, auto range, external
addition off, and effective value measurement
Approval unit Vp-p, Vpk, Vrms, dBV, dBm
Setting with high level/low level, including DC offset, is
also possible.
Vp-p is applied to the standard waveforms and arbitrary
waveform with amplitude range of ±FS.
Vpk is applied to the standard waveforms and arbitrary
waveforms with amplitude range of -FS/0 or 0/+FS.