NF WAVE FACTORY WF1967, Инструкция по эксплуатации

Страница: 153 / 330

4.9 Setting and Operation of Burst
WF1967/WF1968 4-103
c) Screen for triggered gate oscillation setting (second page)

Burst mode [BrstMode]
Set the burst mode. This sets the triggered gate oscillation [TrigGate].

Oscillation Stop Unit [OscStop]
The oscillation stop unit. Select from 1 cycle unit and half period unit.

P.4-104

Trigger [Trig]
The trigger condition.
Select as a trigger source from the inside or outside.

P.4-103

Stop level [StpLvl]
The signal level while oscillation is stopped. Set the level by specifying Off or On.

P.4-105
d) Waveform that trigger gate oscillation is unavailable
DC cannot perform triggered gate oscillation.
Noise can perform triggered gate oscillation, however, the action differs from other waveforms.

P.4-105
e) Setting items necessary for triggered gate oscillation
Set the oscillation start/stop phase [Phase] on the first page of the setting screen.
The stop level [StpLvl] on the second page of the setting screen is usually set as Off [Off].

P.4-105
The oscillation stop unit [OscStop] on the second page of the setting screen is usually set as 1 cycle
[Cycle].

P.4-104
A trigger is necessary for triggered gate oscillation. See the next section.
f) Trigger setting of triggered gate oscillation
Internal trigger oscillator, external signal, manual trigger key operation, and remote trigger can be
used as a trigger.
When a trigger is received, the TRIG'D lamp on the TRIG key lights up.
Set the trigger source in the trigger [Trig] on the second page of the setting screen The trigger delay
is fixed to the minimum value.

Trigger source setting
A trigger source can be selected from internal [Int] or external [Ext].
When a trigger source is internal [Int], a trigger cycle can be set.
When a trigger source is external [Ext], the polarity of a trigger can be set.
When a trigger source is external [Ext], enter a trigger signal with a TTL level to the external trigger
input terminal (TRIG IN).
In addition, channel 2 can select the channel 1 trigger source [Ch1]. (WF1968 only) In this case, the
trigger source selected in channel 1 is shared.

How to use manual and remote triggers
Manual trigger operation and remote trigger operation is effective, regardless of the trigger source
setting.
Stop level
Set the burst mode to
[Trigger]
Pressing the NEXT
key switches the
display to the first
page
Indicates that the second
page is displayed
Trigger
Oscillation stop unit