NF WAVE FACTORY WF1967, Инструкция по эксплуатации

Страница: 296 / 330

17.4 Output Characteristics
WF1967/WF1968 17-6
output terminal voltage under the specified load condition.
Setting range
1Ω to 10kΩ (resolution 1Ω), 50Ω, High-Z (load open)
17.4.4 Waveform Output
Output on/off control On, off (switch) (output terminal is in a released condition
when off)
Output impedance
50Ω, unbalanced
Short-circuit protection Protect against the short circuit to the signal GND
Output connector Front panel, BNC receptacle (FCTN OUT)
Signal GND Insulated from enclosure, maximum 42Vpk (DC +
ACpeak)
Each channel independent. Between channels is also
maximum 42Vpk.
17.4.5 Synchronization/Sub-Output
Output signals Reference phase synchronization, internal modulation
synchronization, burst synchronization, sweep
synchronization, internal modulation signal,
sub-waveform, sweep X drive and off switching
(Forcibly turned off when the oscillation frequency
exceeds 160MHz).
Sub-waveform Analog waveform output synchronized with the
main-output. Phase is variable to the reference phase
synchronization signal, and the amplitude and offset are
also adjustable
Available waveform Sine, square(duty 50%), triangle(symmetry 50%), rising
ramp, falling ramp, noise, arbitrary
Internal modulation waveform Modulation waveform at the time of internal modulation
oscillation. Phase is variable to the reference phase
synchronization signal, and which amplitude and offset
are also adjustable independent from the modulation
depth.
Output voltage (at each type of synchronized signal)
TTL level (low level 0.4V/open or less, high level
2.7V/open or more)
Output voltage (sub-waveform/internal modulation waveform/sweep X drive)
Amplitude setting range 0Vp-p
～
6Vp-p/open setting resolution 1mVp-p
DC offset setting range ±3V/open, setting resolution 1mVp-p
A peak value combining waveform amplitude and DC
offset is limited to ±3V/open or less.
Output impedance
50Ω, unbalanced