NF WAVE FACTORY WF1967, Инструкция по эксплуатации

Страница: 198 / 330

7.4 Simple Arbitrary Waveform Creating Example
WF1967/WF1968 7-6
7.4 Simple Arbitrary Waveform Creating Example
This section creates a simple arbitrary waveform actually. Use the list display to explain the example.
Arbitrary waveform to create is a triangular wave as shown below. The number of control points of this
waveform is three, but in this section, it begins with two points and then changes to three points on the
way.
Check
・
The X value can be changed within a range between the control point just before the
X value and the control point just after the X value.
・
The Y value is rounded to 16-bit resolution.
・
To change the Y value to the form of a step, set the variation width between
adjacent X values to the minimum value, 0.000001.
When the [New] soft key is pressed and the number of control points is set to 2, the
results will be as follows:
Change the setting of Index=1 to X=0.25, Y=+1.
Select the Y value field of the end line (Index=2, X=1) and then press the [Insert] soft
key. The control point with X=0.625000, Y=+0.49998 is newly created. The values
rounded to 16-bit units are displayed as the Y values, assuming ±32767 to be ±1.
Change the setting of Index=2 to X=0.75 and Y=-1. This completes the procedure.