NF WAVE FACTORY WF1967, Инструкция по эксплуатации

Страница: 210 / 330

8.2 Copying Setting between Channels
WF1967/WF1968 8-4
4.
When the above setting is completed, select [OK] at
the bottom of the window, and then press the ENTER
key. The copy operation is performed.
When you do not want to copy, select [Cancel] at the
bottom of the window and press the ENTER key, or
press the CANCEL key.

Remarks
Copying all of [Basic Parameters], [Modulation Parameters], [Sweep Parameters], and [Burst
Parameters] is not equivalent to copying [All Parameters].
The following items are copied only when copying [All Parameters]:
•
Output on/off state
• Oscillation mode
• External addition setting
• User-defined unit
• Start-up output on/off setting
• Waveform parameters setting for all waveforms (for the copy of [Basic Parameters], the
waveform parameters setting is copied only for the currently used waveforms at the copy source)
• Amplitude/DC offset setting or high level/low level setting
Select [OK] and then
press the ENTER key to
make a copy.