In the sequence:
◦
The first set of numbers is the DHCP address for the appliance Storage Node on the
Admin Network, if it is connected. This IP address is assigned to management port 1 on
the E5700SG controller.
◦
The second set of numbers is the DHCP address for the appliance Storage Node on the
Grid Network. This IP address is assigned to 10/25-GbE ports 2 and 4 when you first
apply power to the appliance.
Note: If an IP address could not be assigned using DHCP, 0.0.0.0 is displayed.
•
Provide the MAC address for management port 1 to your network administrator, so they
can look up the DHCP address for this port on the Admin Network. The MAC address is
printed on a label on the E5700SG controller, next to the port.
2. If you were able to obtain either of the DHCP addresses:
a. Open a web browser on the service laptop.
b. Enter this URL for the StorageGRID Appliance Installer:
https://E5700SG_Controller_IP:8443
For
E5700SG_Controller_IP
, use the DHCP address for the controller (use the IP
address for the Admin Network if you have it).
c. If you are prompted with a security alert, view and install the certificate using the browser's
installation wizard.
The alert will not appear the next time you access this URL.
The StorageGRID Appliance Installer Home page appears. The information and messages
shown when you first access this page depend on how your appliance is currently
connected to StorageGRID networks. Error messages might appear that will be resolved in
later steps.
Hardware Installation and Maintenance Guide for SG5700 Appliances
31
Configuring the hardware
