– 860 –
CHAPTER 7
Maintenance Commands
IPAN:
Display of IP machine status display function
1. Functional Outline
This command is used to analyze the connection status between MGC and IP devices; executing ping test,
verifying the station data, and displaying IP equipment information.
(a) Item to be displayed on “Note” field differs by which Tab is chosen.
(b) When “Stn Verify” tab has been chosen, result will be displayed on “Status” field. Meanings of each
item are as shown below.
(c) When you execute “ping” in this command, it is only System-LAN2 that you can set as an origin of
ping packet transmission.
2. Parameters
[Input Data]
MGC (origin of ping packet transmission)
System-0/System-1/Both system
Processing type
Individual/All equipment
Note
The number of times of ping
One Time/Four Times
Change button is provided. Click the radio button SP or LP when changing the origin of ping packet
transmission. Enter the LP number when LP is selected.
Note:
When the processing type “All equipment” is selected, all the connected device data on the tabs of MGC,
IP Terminal, Package, and PHC Point Code are intended to affect. When “Individual” is selected, op-
eration is executed on the basis of each tab.
Display
Meaning
Non
Data coincide
Add
Adding new station data
Change
Changing LENS or IP Address
Delete
Deleting station data
Содержание SV8500
