NEC SV8500, Руководство по эксплуатации и обслуживанию

Страница: 756 / 975

– 709 –
CHAPTER 7 Maintenance Commands
ATRF: Assignment of Traffic Measurement Order
1. Functional Outline
This command is used to assign and delete traffic measurement programs. A request for traffic measurement is
performed when a traffic measurement instruction has been assigned by this command. The collected traffic
measurement data can be stored on the HD of the PCPro, that can be designated on the basis of the traffic
measurement type.
Note: Assign the following when setting Traffic Measurement for Terminal and Route Traffic (ATRF), Connec-
tion Route Traffic and IP Service Traffic:
ASYD, SYS1, INDEX47, bit 0= (0/1=CCS/Erlang)
bit 7=1(Execute Traffic Measurement)
2. Parameters
Input Data
TYPE: Type of Traffic Measurement (1-22) (See Table 7-1.)
Port:Traffic Information Output Terminal Number (0-7:IOC, 8:LAN, 9:NMS)
Interval:Output interval (0, 30-120)
Assign the data (30-120) in ten minute increments. When assigning 0 (available when any of TYPE 3-22
is selected), instead specify your desired output time in the “Output TIME” parameters below.
Start TIME
Note 1
End TIME
Note 1
Output TIME:This data entry is valid only when INTERVAL=0.
Start RT:Start External Route Number (available when TYPE 2/5/8 is selected)
Table 7-1 ATRF - Type of Traffic Measurement Explanation
DATA MEANING DATA MEANING
1 Terminal Traffic 2 Route Traffic
3
Station Peg Count
4
ATT Peg Count
5
Route Peg Count
6
Service Peg Count
8
UCD Route Peg Count
9
UCD Group Peg Count
10
UCD Station Peg Count
15
ATT Answering Peg Count
Note 2
17
CS Peg Count
18
Connection Route Peg Count
Note 3
19 Connection Route Traffic Note 3 20
IP Service Peg Count
21
IP Service Traffic
22
SIP Terminal Peg Count