NEC EXPRESS5800/100 SERIES N8100-1635F, Руководство пользователя

Страница: 50 / 152

3-16 Setting Up Your Modular Server
In the ordinary operation, any cables may not be connected to the connectors on the Modular Server
except for the following cases:
„
Installing OS
„
Maintenance
„
Updating BIOS and firmware
The SUV cable can only be used to connect with the modular server. The SUV cable is a standard
accessory for the N8141-49F Module Enclosure (1way).
The SUV cable has the USB, serial interface, and monitor connectors at the other ends. Connect a
proper device at each of the ends.
IMPORTANT:
„
To connect a peripheral or interface cable provided by a vendor
other than NEC (or third party) to the modular server, make sure
that the device is available for the modular server. Some third party
devices are not available for the modular server.
„
The serial port connector cannot be directly connected with the
leased line.
„
Do not connect/disconnect the SUV cable or add/remove the USB
device until the operating system starts running.
To connect/disconnect the SUV cable or add/remove the USB
device after OS startup, follow restrictions of operating system.
If the device having serial interface is connected, first power off the
modular server and destination device, and remove the power cord
from the destination device before connecting/disconnecting SUV
cable or serial cable. Failure to follow it may cause the devices to be
defected due to the potential difference between them.
„
If you are going to install an OS in the Modular Server, use the SUV
cable. See the next page for connection.
To modular server
To USB devices
To display unit
To serial
interface device