National Instruments Graphical User Interface Ultiboard, Руководство пользователя

Страница: 257 / 281

Appendix A Menus and Commands
NI Ultiboard User Manual A-16 ni.com
Design»Fanout SMD
Use to place a via fanout for a SMD part. Refer to the Placing SMD Fanouts
section of Chapter 5, Working with Traces and Copper , for more
information.
Design»Add Teardrops
Use to add teardrops to pads. Refer to the Adding and Removing Teardrops
section of Chapter 5, Working with Traces and Copper , for more
information.
Design»Corner Mitering
Use to apply corner mitering before production. Refer to the Mitering
Corners section of Chapter 8, Preparing for Manufacturing/Assembly , for
more information.
Design»Remove Unused Vias
Use to delete all vias that do not have any trace segments or copper areas
connected to them. Use this command after
Edit»Copper Delete»Open
Trace Ends to clean up the design. Refer to the Deleting Unused Vias
section of Chapter 8, Preparing for Manufacturing/Assembly , for more
information.
Design»Group Replica Place
Use to copy and place a group of parts. Refer to the Replicating a Group
section of Chapter 4, Working with Parts , for more information.
Design»Copy Route
Use to copy copper routing between groups. Refer to the Copying a Copper
Route section of Chapter 5, Working with Traces and Copper , for more
information.
Design»Highlight Selected Net
Use to select and highlight an entire net when you have selected one trace
segment of that net. Refer to the
Highlighting a Net section of Chapter 5,
Working with Traces and Copper , for more information.