NAC Image Technology MC-529, Руководство пользователя

Страница: 88 / 180

(00235) 3-36
* Press STOP even when recording to the appropriate memory segment has not been completed to
stop recording. Depending on the camera mode when STOP is pressed, the number of frames
saved before recording is stopped will vary.
・
If STOP is pressed during the ARM mode
If the custom setting for the trigger timing is +100%, recording stops when the same number of
frames is saved.
・
If STOP is pressed during the REC mode
Recording stops after saving from the frame where recording was started to the frame at the instant
STOP
was pressed.
3.2.14.7.4 EVENT(L)
Figure 3-44 shows how to switch modes with the J-PAD3 during EVENT(L) recording (top of the figure)
and saving in the memory (bottom of the figure). EVENT(L) is event recording in the LOOP mode.
The sequences for setting four memory segments and for EVENT(L) recording to all of the memory
segments are shown below.
SEGMENT 2 SEGMENT 3 SEGMENT 4 SEGMENT 1
ARM REC ARM REC ARM REC ARM REC
STOP VIEW
event
trigger
automatic switching of the Camera mode and Segment
switching of the Camera mode with the JPAD3 operation
Figure 3-44 Event Recording (EVENT(L), Number of Segments: 4)
1) Verify that the MEMRECAM GX-3 is in the STOP mode.
2) While in the STOP mode, press VIEW/ARM
on the J-PAD3 to switch to the VIEW mode.
The memory segment number (SEG) superimposed on
the image shows "L". The LOOP mode settings are
displayed.
The frame counter (Frame) shows "E". The event
recording settings are displayed.
3) While in the VIEW mode, press VIEW/ARM on the J-PAD3 to switch to the ARM mode.
While the images are overwritten to the appropriate memory segment (SEGMENT1), it awaits trigger
input.
4) While in the ARM mode, press TRIG on the J-PAD3 or use the external trigger for input to switch to
the REC mode. Continue to input event trigger signals from the TRIG1 connector on rear panel or the
J3 cable TRIG2 connector to save the event frames. Recording will end according to the set trigger
timing.
5) Once recording to the appropriate memory segment (SEGMENT1) has been completed, it switches to
the next memory segment (SEGMENT2) and automatically switches from the REC mode to the ARM
mode.