NAC Image Technology MC-529, Руководство пользователя

Страница: 74 / 180

(00235) 3-22
3.2.14.4.2 NORMAL(A)
Figure 3-32 shows how to switch modes with the J-PAD3 during NORMAL(A) recording (top of the figure)
and saving in the memory (bottom of the figure).
NORMAL(A) refers to normal recording in AUTO mode.
The sequence for segmenting the memory into four memory segments and performing NORMAL(A)
recording for memory segment 1 is shown below. The memory should be empty before recording is started.
SEGMENT 2 SEGMENT 3 SEGMENT 4 SEGMENT 1
Memory Protected
ARM REC ARM REC ARM REC ARM REC
STOP VIEW STOP VIEW
switching of the Camera mode with the JPAD3 operation
automatic switching of the Camera mode and Segment
Figure 3-32 Normal Recording (NORMAL(A), Number of Segments
：
4)
1) Verify that the MEMRECAM GX-3 is in the STOP mode.
2) While in the STOP mode, press VIEW/ARM
on the J-PAD3 to switch to the VIEW mode.
The memory segment number (SEG) superimposed on the image is
displayed as "A". Settings in AUTO mode are displayed.
3) While in the VIEW mode, press VIEW/ARM on the J-PAD3 to switch to the ARM mode. While the
images are overwritten to the appropriate memory segment (SEGMENT1), it awaits trigger input.
4) While in the ARM mode, press TRIG
on the J-PAD3 or use the external trigger for input to switch to
the REC mode. Recording will end according to the set trigger timing.
5) Once recording to the appropriate memory segment (SEGMENT1) has been completed, it switches to
the next memory segment (SEGMENT2) and automatically switches from the REC mode to the ARM
mode.
6) Recording
in 4)
～
5) is repeated, and once recording to all of the memory segments has been completed,
it switches from the REC mode to the STOP mode. It does not switch automatically after recording on
the last memory segment (SEGMENT4).
7) Memory segments where recording has been completed are memory protected so will not switch to the
ARM mode. If you wish to start recording again, either change the setting to a recording method other
than the AUTO mode, or erase a memory segment.
* Press
STOP even when recording to the appropriate memory segment has not been completed to
stop recording. Depending on the camera mode when STOP is pressed, the number of frames
saved before recording is stopped will vary.
・
If STOP is pressed during the ARM mode
If the custom setting for the trigger timing is +100%, recording stops when the same number of
frames is saved.
・
If STOP is pressed during the REC mode
Recording stops after saving from the frame where recording was started to the frame at the instant
STOP
was pressed.