NAC Image Technology MC-529, Руководство пользователя

Страница: 77 / 180

(00235) 3-25
3.2.14.5.2 BURST
Figure 3-35 shows how to switch modes with the J-PAD3 during burst recording (top of the figure) and
saving in the memory (bottom of the figure). B1 and B2 refer to the blocks of segmented memory
corresponding to the burst trigger signals.
The sequence for segmenting the memory into four memory segments and performing burst recording for
memory segment 1 is shown below.
SEGMENT 2 SEGMENT 3 SEGMENT 4 B1 B2
SEGMENT 1
STOP VIEW
REC
ARM
burst trigger
on
switching of the Camera mode with the JPAD3 operation
automatic switching of the Camera mode
Figure 3-35 Burst Recording (BURST, number of segments
：
4)
1) Verify that the MEMRECAM GX- is in the STOP mode.
2) While in the STOP mode, press VIEW/ARM
on the J-PAD3 to switch to the VIEW mode.
The frame counter (FRAME) superimposed on the image
is displayed as "B". Burst recording settings are displayed.
"BURST" is displayed for trigger timing (Trigger).
3) While in the VIEW mode, press VIEW/ARM
on the J-PAD3 to switch to the ARM mode.
During burst recording, images cannot be overwritten, even in ARM mode. Also, live images cannot be
updated.
4) While in the ARM mode, input the burst trigger signals from the TRIG1 connector on rear panel or the J3
cable TRIG2 connector to switch to the REC mode.
Images are saved only when the burst trigger signal is ON, and when live images are updated.
Recording ends after the number of frames for the appropriate memory segment (SEGMENT1) are
saved.
5) Once recording to the appropriate memory segment (SEGMENT1) has been completed, it switches to
the STOP mode from the REC mode.
* Press
STOP even when recording to the appropriate memory segment has not been completed to
stop recording. Depending on the camera mode when STOP is pressed, the number of frames
saved before recording is stopped will vary.
・
If STOP is pressed during the ARM mode
If the custom setting for the trigger timing is +100%, recording stops when the same number of
frames is saved.
・
If STOP is pressed during the REC mode
Recording stops after saving from the frame where recording was started to the frame at the instant
STOP
was pressed.