NAC Image Technology MC-529, Руководство пользователя

Страница: 38 / 180

(00235) 2-10
2.6.1 ARM Mode
Caution
）
Before Switching to the ARM Mode
Images saved in the memory will be erased when new images are saved over them by switching
to the ARM mode. Switch to the ARM mode after verifying if the images are to be erased.
Save images needed in a USB compatible storage media or in a control PC. Refer to either
【
2.9 Saving
】
or
【
GXLink User's Manual
】
for the method to save images.
■
Switching to the ARM Mode
Press VIEW/ARM
.
In the VIEW mode, access the ARM mode each time J-PAD3 VIEW/ARM is pressed, and start
recording.
The recording conditions may not be changed until recording stops.
■
Image Display
In the ARM mode, the image photographed is
displayed live. The superimposed information is
displayed at the top and bottom of the screen, and
the camera mode (STATUS) is shown as "ARM"
(Figure 2-14).
Once recording starts, all of the superimposed
information is shown in red.
After trigger input, the number of saved frames is
displayed in the frame counter (Frame) according to
the trigger timing (Trigger). Refer to
【
3.2.1 Trigger
Timing Selection
】
for trigger timing.
With Trigger, "*" is displayed until recording has
ended.
■
J-PAD3 Display
The status screen is shown in Figure 2-15, and
the camera mode "ARM" is displayed. The
established recording conditions are shown in the
ARM mode status screen.
The frame "TIME" cannot be determined until
recording has ended, so "
＊
" is shown.
"0" is shown in the frame counter (FRAME) until
recording has ended.
■
Rear Panel LED Display
During the STOP mode,the CM LED is lit up in magenta.
Figure 2-15 Image Display (ARM Mode)
Figure 2-16 J-PAD3 Display (ARM