NAC Image Technology MC-529, Руководство пользователя

Страница: 35 / 180

(00235) 2-7
2.4 Stop (STOP Mode)
■
Switching to the STOP Mode
Press STOP
.
MEMRECAM GX-3 normally starts up in the STOP mode. If operating in any mode other than STOP,
press J-PAD3 STOP to stop operation and access the STOP mode.
Settings relating to recording conditions, playback conditions and storage are performed in the STOP mode.
Refer to
【
3 Recording and Playback Settings
】
and
【
4 Save Settings
】
for these settings.
■
Image Display
The test recorded image is displayed during the
automatic diagnostics at startup. Information is
superimposed at the bottom and top of the screen
and the camera mode (Status) is displayed as
"STOP" (Figure 2-9). At this point, the memory is
empty and the superimposed information indicates
"
＊
" for the image.
The memory segment number (SEG) and the
playback speed (PLAY) are shown regardless of the
presence of recording memory.
The superimposed information displayed in blue is
information relating to the image saved in the
memory or playback information
Caution
）
In the starting at the time of backup by a Battery, the already recorded image (image at the time
of the last operation) is displayed.
■
J-PAD3 Display
The status screen is shown in Figure 2-10, and
the camera mode "STOP" is displayed. At startup, if
the memory is empty, the factory settings are shown
on the status screen.
The "TIME" cannot be determined until recording
has ended, so "
＊
" is shown.
The playback range bar is shown empty.
■
Rear Panel LED Display
During the STOP mode,the CM LED is lit up in blue.
Figure 2-10 J-PAD3 Display (STOP Mode)
Figure 2-9 Image Display (STOP Mode)