NAC Image Technology MC-529, Руководство пользователя

Страница: 84 / 180

(00235) 3-32
* Press STOP even when recording to the appropriate memory segment has not been
completed to stop recording. Depending on the camera mode when STOP is pressed, the number
of frames saved before recording is stopped will vary.
・
If STOP is pressed during the ARM mode
If the custom setting for the trigger timing is +100%, recording stops when the same number of
frames is saved.
・
If STOP is pressed during the REC mode
Recording stops after saving from the frame where recording was started to the frame at the instant
STOP was pressed
※
3.2.14.6.5 MULTIS(L)
Figure 3-41 shows how to switch modes with the J-PAD3 during MULTIS(L) recording (top of the figure)
and saving in the memory (bottom of the figure). MULTIS(L) is multi trigger recording in the LOOP mode.
The sequences for setting two memory segments and four blocks, and for MULTIS(L) recording to all of
the memory segments are shown below.
B1 B2
SEGMENT 1
STOP VIEW
ARM REC
B3 B4
ARM REC ARM REC ARM REC
B1 B2
SEGMENT 2
B3 B4
ARM REC ARM REC ARM REC ARM REC
switching of the Camera mode with the JPAD3 operation
automatic switching of the Camera mode, Segment and Block
Figure3-41 Multi Trigger Recording (MULTIS(L), Number of Segments: 2, Number of Blocks: 4)
1) Verify that the MEMRECAM GX-3 is in the STOP mode.
2) While in the STOP mode, press VIEW/ARM
on the J-PAD3 to switch to the VIEW mode.
The memory segment number (SEG) superimposed on
the image shows "L". The LOOP mode settings are
displayed.
The frame counter (FRAME) superimposed on the image
shows "04 A". There are 4 blocks displaying the ALL
BLOCKS mode setting.
3) While in the VIEW mode, press VIEW/ARM on the J-PAD3 to switch to the ARM mode.
The frame counter (Frame) displays "01 A". While the
images are overwritten to block 1, it awaits trigger input.
4) While in the ARM mode, press TRIG on the J-PAD3 or use the external trigger for input to switch to
the REC mode. Recording will end according to the set trigger timing.
5) Once recording to the appropriate block (B1) has been completed, it switches to the next block (B2) and
automatically switches from the REC mode to the ARM mode.