way, push the bottom button momentarily. The awning will extend until it
reaches the full extend position. Pressing the top button will retract the awning.
The awning can be stopped in either direction, at any point, using the center
stop button.
CAUTION: The motor is not designed for continuous use. In
the event that the motor is used to excess, it will automatically
shut off and be inoperative until internal breaker cools down
and resets. The run time is four to five minutes per hour.
Reset time will be 30 minutes to one hour depending on the
outside temperature.
The awning will then extend to its full projection. To retract the awning, put
the switch in the
UP
position. There is no need to hold the switch once it has
been activated. To stop the awning at any point in its projection or retraction,
move the switch to the center position. The switch should be left in the center
position at all times when the awning is stationary. The motor used in the
Girard uses 300 watts and draws approximately three amps of power.
Manual Operation:
To manually operate the awning, use the telescoping crank handle supplied
and follow the instructions in Manufacturer's manual.
Wind Sensor:
The awning is fitted with a wind sensor which is designed to retract auto-
matically in the event of high winds, as long as it has 110 Volt power supply
and wind has unrestricted access to wind sensor cup on roof of motorhome.
Push the bottom button to extend the awning and the top button to retract it.
The awning can be stopped at any point by pushing the center button marked
STOP
.
The wind sensor dominates and will override any push button commands in
the event of excessive winds. In the event that the wind sensor is activated, the
awning will close completely. The awning will not re-open automatically.
It must be opened by using the extend button once again. This features is
intended to prevent the awning from extending or retracting excessively,
further preventing possible overheating of the motor.
Care and Cleaning of Acrylic Fabric:
The acrylic fabric should be cleaned regularly before substances such as
dirt, leaves, etc., are allowed to accumulate on, and become embedded in, the
fabric. The fabric can be cleaned without being removed from the awning.
Simply brush off any loose dirt, leaves, etc. Hose down and clean with a cloth
and mild soap. DO NOT USE DETERGENTS. Allow to air dry, preferably on
a warm sunny day. Should you have to retract the awning when the fabric is
wet, it should be extended at the first opportunity to finish air drying.
Appliance & Equipment
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
E X E C U T I V E
3 • 9 6
Содержание Executive 2001
