Electrical Systems
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Transmission Key Pad:
The function of each position of the keypad push-button shifter is as follows:
• Select the REVERSE gear by pressing
R
.
• Select NEUTRAL by pressing
N
. The area around the
N
button is a raised
ridge so the driver can orient his hand to the push buttons by touch,
without looking at the display.
• Select DRIVE range by pressing
D
. The highest forward gear will appear
on the
SELECT
display and the transmission will shift to the starting gear.
• The UPSHIFT and DOWNSHIFT
arrow
buttons are used to select a
higher (if not in
D
) or lower (if not in
1
)forward range. These buttons are
not functional in NEUTRAL or REVERSE. One press changes the range
selected by one range. If the button is held continuously, the selected range
will continue to change up or down until the button is released or until the
highest/lowest possible range of gears is selected.
• The fluid level of the transmission can also be checked from the shift
selector keypad. The up and down arrow button will need to be pressed
simutaenously when the motorhome is at a rest position. This activates the
diagnostic circuitry of the transmission. Exiting the diagnostics is
accomplished by pressing
N
.
NOTE: The oil level sensor method of checking the fluid level com-
pensates for transmission fluid temperature between 60º C - 104º C
(140º F - 220º F). Any temperature below 60º C(140º F), or above 104º
C (220º F), will result in an Invalid for Display condition.
• The MODE button will enable secondary shift point to be selected. This is
commonly referred to as “Economy.” It is further used by the service
technician to access diagnostic codes when troubleshooting. The
diagnostic circuitry must be enabled to display the codes.
1. Gen ON/OFF:
Starts and stops generator form the dash area.
2. Gen IN/OUT:
Operates hydraulic slide out for generator access.
NOTE: The Generator IN/OUT switch is deleted on motorhomes
with an acrylic front protective mask.
3. Brake HI/LO (On the ISM engine only):
High setting activates engine brake on six cylinders. Low setting
activates engine brake on three cylinders.
5 • 1 6 9
EXECUTIVE
R
N
D
6
MODE
Transmission Key Pad.
Содержание Executive 2001
