Monaco Executive 2001, Руководство пользователя

Страница: 183 / 269

Periodic resealing of the joints and seams is necessary to prevent the entrance of
moisture into the motorhome. There can not be enough emphasis placed on this
issue. Great amounts of damage from a water leak can occur very quickly. Never
leave the vehicle unattended with the slide room in the out position. If the vehicle is
to be stored outside over the winter months, a bi-monthly full interior inspection for
water leaks should be made. Extensive sealing has be done at the factory, however
the twisting and flexing that occurs when traveling may have compromised a seal or
seam. All joints and seams should be inspected at least twice a year and recalked as
necessary. Special attention should be directed toward the roof air conditioning
seals, ceiling and plumbing vents, skylights, roof mounted antennas, windows, door
moldings, clearance lights and the beltline molding. Specific sealant products should
be used in the areas for which they were designed. These items can be obtained from
recreational vehicle parts suppliers. Listed below are some of the more common
sealants and the areas in which they are used. Approved sealants are available at
service centers and authorized dealers.
WARNING: Products may contain hazardous materials which require
special handling. Read labels carefully. Follow all product manufacturer’s
safety requirements.
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Acryl-R:
This product is used on all roof openings such as vents and skylights, any roof
mounted antennas, ladder roof mounts with the exception of the roof air condition-
ers. Sealant should be applied only where the equipment bases meet the roof. Clean
old sealant that is lifting before applying with new. Make sure roof is dry and free of
dirt. This product is usually found in a caulking tube. Care should be used when near
an edge, as product will spread out. Masking tape may be used to mask around area
to avoid mishaps.
The roof air conditioners have closed cell foam base gaskets. No sealants are
required. The roof air conditioners should be checked for tightness by the four
mounting bolts located in each corner of the air conditioner roof opening. Torque
specification is 40-50 in/lbs. Base gasket should be compressed to approximately
1/2”.
Clear Silicone Sealant:
Primarily this product is used on the sidewalls where a hole has been made and
an item installed. This includes Windows, Doors, Handles, Beltline Moldings,
Latches and around bases of items surface mounted such as clearance lights.
Old peeling sealant should be removed. Avoid using metal utensils as this will
scratch the painted surface. Use nylon sticks or equivalent. Avoid using lacquer thin-
ners or ketone based solvents as these can damage the painted surfaces. Be sure sur-
face is clean and dry before application. Cut tube at an angle with smallest usable
opening. Avoid a heavy bead as a little goes a long way. Use finger at a 45 degree
angle on beaded surface to smooth out product. Do not moisten finger, use a dispos-
Unit Care & Maintenance
----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
E X E C U T I V E 6 • 1 8 3
Seal Inspections
Sealant Types